Victor pumps

Victor produces self-priming centrifugal pumps and gear pumps with internal teeth, also called pinion pumps.

Victor self-priming centrifugal pumps are equipped with a half-open impeller with sliding plates in front of, and behind, the impeller which makes them ideal for pumping waste water containing solids.

Victor S pumps are available in cast iron, bronze and stainless steel AISI 316.
Victor pumps are supplied in monoblock versions, but with a bearing unit or a bearing unit with a built-on bell housing. This latter version is called a Victor bi-block. Its advantage is that it uses a heavy bearing unit with a standard normalised IEC electric motor, thus avoiding the need for any re-alignment.

Victor gear pumps or pinion pumps are equipped with internal teeth. These Victor pumps are widely used in the paint and ink industries, the fodder industry and the chemical industry and are ideal for pumping highly viscous liquids including paint, ink, glue, molasses, vinasse, bitumen, chocolate, cocoa etc.

Victor gear pumps can be produced in cast iron GGG 40 or stainless steel AISI 316. These Victor gear pumps can even be supplied with a heat jacket, depending on the liquid to be pumped. The Victor pumps are available with Tungsten carbide bearings and shafts for use with abrasive liquids.

Do you have any questions?

Would you like to speak to us directly?
Please call
+31 (0)88 4802 900.

Perhaps you would prefer to send your question by e-mail? Then please fill out the form.

Your information:

The form was not submitted

The following fields are filled out incorrectly:

  •  

Close